Solution after gear wear of hard tooth surface reducer

Release time:

2024-04-23

As an essential component of screw lift and other transmission products, the stability of the hard tooth surface reducer plays an important role in the whole transmission system. However, if the hardness of the hard tooth surface reducer fails to meet the requirements during the purchase process, or the use cycle is too long, or the overload is too long, it will accelerate the wear of the hard tooth surface gear, which will affect the normal operation of the transmission system.

Solution after gear wear of hard tooth surface reducer

One: the main manifestation of failure after long-term use: the vibration increases and the noise increases during use. The main reason for this phenomenon is that the internal parts of the chassis are too worn or damaged.

Two: Parts that may be damaged: gear tooth surface wear, gear tooth breakage, gear gear shaft hole or keyway wear; screw hole at bearing hole is easy to fail due to wear; shaft surface and keyway are also easy to use for too long And wear.

Three: repair method: this repair method is not all maintenance department has the technical strength to carry out maintenance according to this method, but if it is large equipment, can find a maintenance point to repair parts, the overall cost of the enterprise will be greatly saved.
01: If it is because of the hard tooth surface reducer shaft hole keyway wear, etc., can take the method of electroplating parts to restore the original accuracy.
02: If the gear teeth of the hard tooth surface reducer are broken and damaged, only new parts will be reprocessed. In order to ensure the use of hard tooth surface reducer cycle, friends in the purchase of hard tooth surface reducer must choose a good type, to ensure the safety factor of hard tooth surface reducer, and strictly follow the instructions to operate, in order to play the maximum effect of hard tooth surface reducer.